Settings for indoor air quality monitoring solution

Settings to configure this solution after it is active in your facility

Solution categories

Alerts from the air quality monitoring solution operate based on following two categories

Category 1 - For air quality alerts based on anomaly detection and counting Category 2 - New: For air quality alerts based on ammonia threshold.

Note:

• Category 1 is active by default for air quality monitoring solution in your Project.
• To switch your Project to use Category 2 for bad air quality alerts, contact us:
  • Preferably, open a support ticket with us.
  • Or, contact your SmartClean account manager / drop us an email.

What settings are available?

To configure this solution, the following settings are available (by category):

Category 1 - For AQ alerts based on anomaly detection and counting

Configure per device

1. Air quality anomalies limit
   • Type: maximum threshold
   • Description: This threshold represents the total number of air quality anomalies in a certain duration.
   • Outcome: Incident about unexpected air quality will be created for the location that the device is assigned to.
2. Duration to check air quality anomalies
   • Type: time duration
   • Description: The duration to count the number of air quality anomalies reported by the sensor.
   • Outcome: Notify intended users about unexpected air quality detected recently in the zone.

Category 2 - New: For AQ Alerts based on ammonia threshold.

Configure per device:

1. Maximum Ammonia Threshold
   • Type: maximum threshold
   • Description: This threshold represents the maximum ammonia value (undesirable level) in surrounding air.
   • Outcome: Incident about bad air quality will be created for the location that the device is assigned to.

Note: Unless Category 2 is activated for the air quality monitoring solution in your Project, Category 1 is applicable.

Go back to solution settings

---